Apply Geometric Dimensioning & Tolerancing at Intermediate Level
Training Provider: ASSETS TRAINING & TECHNICAL SERVICES PTE. LTD.
Course Reference: TGS-2019501400
S$420
Original: S$840
Save S$420
About This Course
Address the performance gap to interpret and apply tools, concepts, rules and processes according to ASME Y14.5-2009 international standard.
Provide participants a practical knowledge on performing inspection of GD&T controls
What You'll Learn
1. Introduction of GD&T
2. Modifier/Boundaries/Envelops/Control Frames
3. General Rules
4. Datum Theory/Datum Systems
5. Position tolerancing
6. Geometric Controls/Inspection Techniques
2. Modifier/Boundaries/Envelops/Control Frames
3. General Rules
4. Datum Theory/Datum Systems
5. Position tolerancing
6. Geometric Controls/Inspection Techniques
Entry Requirements
Post Secondary (Non-Tertiary) General & Vocational
Course Details
Back to All Courses
Note: To apply for this course, visit the SkillsFuture website or contact the training provider directly.
More Courses from ASSETS TRAINING & TECHNICAL SERVICES PTE. LTD.
Targeted sectors are Chemical, Energy, Process, Oil & Gas sectors that will normally considered as M...
The course targets candidates working in the Major Hazard Installation sector of Singapore with know...
a) Understand electrical safety and standard.
b) A fundamental understanding of electrical and
...